Dallas–Fort Worth
Plumbing Fixture Installation in Dallas–Fort Worth
A new fixture is only as good as the connections behind it. We install faucets, toilets, sinks, disposals and shower trim so that they sit level, seal the first time and stay dry.

What the work involves
Installing a fixture looks simple, and nine tenths of it is. The last tenth is where leaks come from: a supply nut tightened slightly crooked, a drain assembled without the right seal, a toilet set on a flange that sits below the finished floor. Those details decide whether a fixture is quietly forgotten about or leaves a stain on the ceiling of the room below.
We check the fixture against the plumbing before anything is taken apart: the rough-in distance for a toilet, the hole spacing and deck thickness for a faucet, the valve body behind a shower trim kit. It is far better to learn that a fixture will not fit while the old one is still working than after it has been taken out.
Fixtures we install
- Kitchen and bathroom faucets, including pull-down and widespread styles
- Toilets, bidet seats and replacement fill and flush assemblies
- Kitchen, bar and vanity sinks, both undermount and drop-in
- Garbage disposals and dishwasher connections
- Shower and tub trim, shower heads and hand showers
Step by step
How the visit goes
Confirm the fit
Rough-in, hole spacing and valve compatibility are checked before the old fixture comes out.
Agree the price
Before anything is disconnected, the cost of the installation is put to you, and work begins only when you have approved it.
Set it level and sealed
The fixture is seated on the correct seal, leveled, and tightened by feel rather than by force, so nothing cracks or distorts.
Run it and check it dry
The fixture is filled, flushed or run several times and each joint is checked with a dry hand. The room is clean again before we go.
Local notes
Worth knowing in North Texas
Many homes across the northern suburbs were built in the 1980s, 1990s and 2000s, and plenty still have their original multi-turn shut-off valves under the sinks and behind the toilets. After decades in hard water those valves often will not close fully, or they begin to seep at the stem once they are disturbed. It is worth trying yours before a new fixture goes in: a valve that will not shut, or that weeps once it has been turned, is easier to deal with while the cabinet is already open.
Fixture Installation
Common questions
Does a new bathroom faucet need a new drain as well?
Usually, yes. Many bathroom faucets are sold with a matching drain assembly, and fitting it at the same time means the finishes match and the old seals are not reused. A kitchen faucet does not come with one; the sink strainers stay unless they are leaking or corroded.
How do I know a new toilet will fit?
Measure from the finished wall behind the toilet to the center of the bolts that hold it to the floor. Twelve inches is the common rough-in, though ten and fourteen exist in some homes. Bowl shape matters too: an elongated bowl reaches about two inches farther into the room than a round one.
Will a new shower trim kit work with my existing valve?
Only if it was made for that valve. Trim is specific to the manufacturer and often to the valve series, so a handle and plate from one maker will not fit another maker's valve body. If you would like a different brand or style, the valve in the wall is replaced as well, which is a larger job and is priced separately.
Service area
Where we do this work
Available to homes across Dallas–Fort Worth. For local detail, each city below has a page on its houses and their plumbing.
